| News |
|
|
 |
|
|
| Your Location£ºHome > News > Longxiang News |
| PCB design board edge supplements and distance problem between the lines |
|
|
Q: General PCB design, must remain in parts of the plate edge distance was not much in the cause of the electrical impact if material is FR4, both sides have FC parts, there are inter-connected board design, board and board have Routing and V? -CUT two ways to deal with?
A: This question and SMT equipment has a lot to stay at least most of the equipment plate edge 0.150inch (4-6MM) as a transport to a safe distance if PANEL splint design is among Piece and piece of. V-CUT processing can be broken or drilled TABS. It should be noted V-CUT path width to remain above 20-30mil needs no conductor (with V-CUT to both sides of the center line count)
For reprint please indicate by www.pcba.co
|
|
¡ºBack¡»
|
|
 |
|
